APRILIA RSV mille Workshop Manual page 223

ELECTRIC SYSTEM
ã
Follow
LOW BEAM BULB
N
Move the protection element (10) with your hands.
N
Withdraw the bulb electric connector (11).
N
Rotate the bulb socket (12) anticlockwise and extract it
from its seat.
N
Extract the bulb (3) from its seat and replace it with a
new one of the same type.
NOTE
Insert the bulb in the bulb socket, making the rel-
evant positioning seats coincide.
ò LOW BEAM BULB
NOTE
Extract the connectors one by one, in such a
way as to avoid positioning them wrongly upon reassem-
bly.
If it is necessary to remove all the connectors at the same
time, mark them and make sure that you position them
correctly upon reassembly.
N
Remove the front part of the fairing, see 7.1.22 (RE-
MOVING THE FRONT PART OF THE FAIRING).
N
Move the protection element (10) with your hands.
a
CAUTION
To extract the bulb electric connector, do not pull its
wires.
N
Grasp the bulb electric connector (11), pull it and dis-
connect it from the bulb.
N
Release the two ends of the check spring (13) posi-
tioned on the bulb socket (12).
N
Extract the bulb from its seat.
NOTE
Insert the bulb in the bulb socket, making the re-
spective positioning seats (A) coincide.
N
Correctly install a new bulb of the same type.
Upon reassembly:
NOTE
Put back the protection element (10) with the
cable passage facing downwards.
6 - 42
- 00
RSV mille
Release 00/2002-10