APRILIA RSV mille Workshop Manual page 65

SERVICE AND SETTING UP
 %,%#42)# #/-0/.%.43
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
Light operation/direction, light system, safety switch-
es:
for the maintenance intervals, see 2.1.1 (REGULAR
SERVICE INTERVALS CHART).
For the check, proceed as follows:
N
Position the vehicle on the stand.
N
Check all the lighting devices are working.
N
Check the direction of the headlight beam is correct,
see 6.13 (ADJUSTING THE VERTICAL HEADLIGHT
BEAM) and 6.14 (ADJUSTING THE HORIZONTAL
HEADLIGHT BEAM u).
N
Make sure all connectors are inserted properly.
N
Make sure all switches are correctly fastened and in
proper working order, see:
– 6.6.4 (CHECKING THE SIDE STAND AND THE
SAFETY SWITCH).
– 6.16 (CHECKING THE SWITCHES).
N
Make sure the air sensor and speedometer sensor are
correctly fastened and in proper working order.
a
CAUTION
The sensitive area on the sensors must be kept clean
at all times. Any mud, dirt etc. on them is liable to al-
ter the measurements and the subsequent data trans-
fer.
2 - 16
- 00
RSV mille
Release 00/2002-10