CHASSIS
7.6.4.
FINAL DRIVE REMOVAL
Read
1.2.1
carefully.
DISASSEMBLY
•
Remove the wheel; see
NOTE If you only need to remove the rear chain sprocket,
simply perform the following five steps.
•
Clean the wheel hub at both ends with a cloth.
•
Remove the circlip (1).
•
Remove the snap ring (2).
•
Release and remove the five screws (3).
•
Remove the rear sprocket (4).
•
Clean the hub bore thoroughly.
NOTE Wash all components with clean detergent.
If needed:
•
Remove the sprocket carrier (5) and collect the five
nuts (6).
•
Remove the cush-drive rubber (7).
REASSEMBLY
•
With the sprocket carrier (5) removed, fit the rear
sprocket (4) to the carrier and tighten the five nuts (6).
WARNING
Tighten the nuts in a cross pattern.
•
Refit the cush-drive rubber (7) into the wheel.
•
Refit the sprocket carrier (5) together with the rear
sprocket (4) to the wheel.
•
Refit the snap ring (2).
•
Refit the circlip (1).
•
Refit the wheel; see
7 - 72
7.6.2.
7.6.6.
3
1
2
4
5
RS 125
6
7