Toyota Tundra 2005 Service - Repair - Maintenance page 1291

1 Check other DTCs output (in addition to DTC P0711).
PREPARATION:
(a) Turn the ignition switch off.
(b) Connect the OBD II scan tool or hand−held tester to the DLC3.
(c) Turn the ignition switch to the ON position.
(d) Turn on the tester.
(e) Select the item "DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES".
CHECK:
Read the DTCs using the OBD II scan tool or the hand−held tester.
RESULT:
"P0711" and other DTCs
HINT:
If any other codes besides "P0711" are output, perform troubleshooting for those DTCs first.
A
2 Check transmission fluid level (See page DI−952).
OK:
Automatic transmission fluid level is correct.
OK
Replace the transmission wire
(ATF temperature sensor)
(See page AT−9).
DIAGNOSTICS
Display (DTC output)
Only "P0711" is output
− AUTOMATIC TRANSMISSION (A750E for 1GR−FE)
B Go to DTC chart (See page DI−991).
(See page DI−952).
NG Add fluid
Proceed to
A
B
DI−1007