Xilinx Kintex UltraScale FPGA KCU1250 Getting Started Manual page 16

Setting Up the Vivado Design Suite
1. Connect the host computer to the KCU1250 board using the second standard-A plug to
micro-B plug USB cable. The standard-A plug connects to a USB port on the host
computer and the micro-B plug connects to U80 (the Digilent USB JTAG configuration
port on the KCU1250 board
X-Ref Target - Figure 1-13
KCU1250 IBERT Getting Started Guide
UG1061 (v2017.4) December 20, 2017
Chapter 1: KCU1250 IBERT Getting Started Guide
(Figure 1-13)).
Figure 1-13: USB-UART Connector
www.xilinx.com
16
Send Feedback