Xilinx Kintex UltraScale FPGA KCU1250 Getting Started Manual page 13

3. Connect J1 connector (USB/UART) on the KCU1250 board to the host computer using
one of the standard-A plug to micro-B plug USB cables provided
4. Power up the board by placing SW1 in the ON position.
X-Ref Target - Figure 1-11
5. Open a serial communication terminal application on the host computer, for example
"Hyper Terminal".
6. Connect to the port number associated with the enhanced COM port of the Silicon Lab
USB-UART Bridge.
KCU1250 IBERT Getting Started Guide
UG1061 (v2017.4) December 20, 2017
Chapter 1: KCU1250 IBERT Getting Started Guide
Figure 1-11: USB-UART Connector
www.xilinx.com
(Figure 1-11).
13
Send Feedback