Xilinx Kintex UltraScale FPGA KCU1250 Getting Started Manual page 9

For more information on the SuperClock-2 module, see the HW-CLK-101-SCLK2
SuperClock-2 Module User Guide (UG770)
Attaching the GTH Quad Connector
1. Before connecting the Bulls Eye cable assembly to the board, firmly secure the blue
elastomer seal provided with the cable assembly to the bottom of the connector
housing if it is not already inserted (see
Figure 1-4
Note:
connector.
X-Ref Target - Figure 1-4
2. Attach the Samtec Bulls Eye connector to GTH Quad 224
indexing pins on the bottom of the connector with the guide holes on the board. Hold
the connector flush with the board and fasten it by tightening the two captive screws.
X-Ref Target - Figure 1-5
KCU1250 IBERT Getting Started Guide
UG1061 (v2017.4) December 20, 2017
is for reference only and might not reflect the current version of the
Figure 1-4: Bulls Eye Connector with Elastomer Seal
Figure 1-5: Bulls Eye Connector Attached to Quad 224
www.xilinx.com
Chapter 1: KCU1250 IBERT Getting Started Guide
[Ref 2].
Figure 1-4).
(Figure 1-5), aligning the two
9
Send Feedback