VKI Technologies CAFFÈ MIO Operation & Service Manual page 98

R e p l a c i n g M a j o r C o m p o n e n t s
8. Place the new inlet valve into position and secure it with the two screws.
a) These screws are located on the outside of the rear wall of the machine.
9. Connect wires #6 and #1-2 onto the inlet valve.
10. Secure the inlet valve hose (using a hose clamp) to the inlet at the bottom of the water tank.
11. Make sure that the drain plug on the bottom of the tank a closed (pulled down) and locked with
the locking clip. Also make certain the large clamp at the end of the drain hose is closed.
12. Connect a fitting to the inlet valve at the back of the machine, and connect a water source to the
fitting.
13. Turn on the water supply and switch the coffee maker "ON", and check for leaks.
CAFFÈ MIO – OPERATION AND SERVICE
S E C T I O N
Water Tank
Inlet Hose
5 – R E P L A C I N G
Connect Wires
Inlet
Valve
C O M P O N E N T S
Page 98 of 110