VKI Technologies CAFFÈ MIO Operation & Service Manual page 72

R e p l a c i n g M a j o r C o m p o n e n t s
8. To install the new dispenser, lower in into position from the top of the machine and align the
coupler at the rear of the dispenser with the drive pin on the dispenser motor.
9. Slide the rear of the dispenser support into the cutout on the base, and push the dispenser back
to couple it with the motor. The pin at the bottom of the dispenser will go into the notch on the
base to help guide the dispenser into position.
Support Cutout
CAFFÈ MIO – OPERATION AND SERVICE
S E C T I O N
Dispenser Motor
Support Cutout
Ingredient Dispenser
Ingredient Dispenser
Support
Dispenser Base
5 – R E P L A C I N G
Drive Pin
Coupler
Guide Pin
Notch
C O M P O N E N T S
Page 72 of 110