VKI Technologies CAFFÈ MIO Operation & Service Manual page 46

R e p l a c i n g M a j o r C o m p o n e n t s
7. Insert the tip through the pour spout on the cylinder.
8. Gently push extractor tool towards rear of cylinder and slide tip up until contact is made with
rear of filter screen's plastic frame.
9. Once tip is centered under rear section of filter screen's frame, pry handle section to force tip
upward. Resulting force will dislodge the filter screen, which can then be removed.
10. Align the new filter screen in recession on the top of the brewer cylinder. The round protrusion
on the screen must be at the rear to properly align with the cylinder.
11. Push the screen down into the top of the cylinder until it snaps in place, at which point it should
be flush with the top of the cylinder.
12. Re-install the brew chamber and brewer spout.
13. Press the "coffee" button on the front selection panel to close the brewer.
14. Press the "SET-UP" button on the interior panel to exit the set-up mode.
15. Test brew a few cups of coffee to verify the brew operation.
16. Close the inner door and front door.
CAFFÈ MIO – OPERATION AND SERVICE
S E C T I O N 5 – R E P L A C I N G C O M P O N E N T S
Page 46 of 110