VKI Technologies CAFFÈ MIO Operation & Service Manual page 94

R e p l a c i n g M a j o r C o m p o n e n t s
13. Install the whipper base support bracket.
c) Lower the bracket onto the four loose screws.
d) Tighten the screws to secure the bracket in place.
14. Clean all of the parts that were removed earlier under warm running water prior to replacing them.
15. Install the whipper base onto the metal support and secure it in place with the two screws.
16. Re-install the whipper blade.
a) The whipper blade and whipper motor shaft have a "D" type fit. The line at the rear or the
blade must line up with the flat spot on the motor shaft.
CAFFÈ MIO – OPERATION AND SERVICE
S E C T I O N
Tighten
Tighten
Install
Alignment Line
These two areas must
be aligned to install
the whipper blade
5 – R E P L A C I N G
Tighten
Tighten
Install
C O M P O N E N T S
Page 94 of 110