Wheel / Tire Replacement - Farm King HS8525 Operator And Parts Manual

WHEEL / TIRE REPLACEMENT

CHECK WHEEL BOLTS AFTER:
1. First five hours of field operation.
2. First twenty-five hours of field operation.
3. First fifty hours of field operation.
4. Every two hundred hours of operation.
REPEAT PROCEDURE IF A WHEEL IS
REMOVED OR REINSTALLED
Periodically check tires for cuts, bulges and damaged
rims.
AVOID INJURY OR DEATH
Before you leave the operator's position:
• Always park on a flat level surface.
• Place all controls in NEUTRAL.
• Engage the park brake.
• Stop the engine and remove the key.
• Wait for all moving parts to stop.
Park the tractor / equipment on a flat level surface.
Lower the wings.
Place all controls in neutral, engage the park brake, stop
the engine and wait for all moving parts to stop. Leave
the operator's position.
96
Maintenance - High Speed Compact Disc
AVOID INJURY OR DEATH
• Always chock tires before performing any
maintenance or service.
Place chock blocks behind and in front of the opposite
tire to be removed.
Raise axle frame with jack until the tire / wheel is slightly
off the ground.
NOTE: Place blocks / stands under the frame to
secure the equipment when tire / wheel is
raised off the ground.
Figure 154
1
7
3
9
5
NOTE: Place blocks / stands under the frame to
secure the equipment when tire / wheel is
raised off the ground.
Remove the wheel bolts or nuts and remove wheel.
Install the new tire with the valve stem facing out.
Reinstall ten wheel bolts (1 - 10, Figure 154).
Tighten wheel bolts / wheel nuts (1 - 10) in a criss-cross
pattern (see Wheel Bolt Torque on page 158).
6
10
4
8
2
1590