Figure 124
2
1. Place the slow moving vehicle sign (1, Figure 124) on
the LH brake / tail light bracket as shown.
2. Install two 1/4" x 1" bolts, lock washers and nuts (2)
Figure 125
4
7
5
6
NOTE: Remove the cap from manual storage
container when installing.
1. Align the manual storage container (1, Figure 125)
with the holes on the inner right side of the hose
bracket.
2. Install two 5/16" x 3/4" bolts (2), 5/16" lock nuts (3)
and tighten. Reinstall the cap.
3. Install electrical storage plug (4) on the left side of the
hose holder using one 1/4" x 5/8" bolt (5), 1/4" lock
washer and 1/4" nut.
64
2
1
B-17142
2
1
2
B-17043
4. Route the light wire harness (6) along the hydraulic
hoses, through the front of the hose holder.
5. Install the light harness 7-pin connector (7) into the
electrical storage plug.
3
3
Assembly - High Speed Compact Disc