Base Group; Center Frame And Wings Assembly - Farm King HS8525 Operator And Parts Manual

BASE GROUP

Center Frame and Wings Assembly

Assemble the center frame and wings on a flat level
surface.
• DO NOT permit bystanders to be in the work area
when lowering, raising or folding wing.
• DO NOT work under suspended parts.
• Keep away from moving parts.
• Always use lifting devices / vehicles, chains or
straps of adequate size and strength when
unloading and
components.
AVOID INJURY OR DEATH
Keep fingers and hands out of pinch points when
assembling the equipment.
32
assembling the equipment
Assembly - High Speed Compact Disc
NOTE: The following
assembly section of this manual may not
show your exact model components as they
appear but the procedure is correct.
Always use chains, straps and lifting devices that
are in good condition and of adequate size to lift the
equipment components.
Figure 12
2
REAR
2
1. Install straps on both sides of the center frame (1,
Figure 12). Connect the straps to an approved lifting
device.
2. Raise and move the center frame to the assembly
area. Place support stands under each corner of the
center frame.
3. Lower the center frame onto the support stands.
4. Install a bushing (2) at each end, on the right side of
the center frame.
5. Install a bushing at each end on the left side center
frame.
6. Apply a coat of anti-seize to the inside of each
bushing.
images throughout
FRONT
2
1
B-17000
the