Farm King HS8525 Operator And Parts Manual page 39

Figure 37
4
2
1. Install a strap and approved lifting device onto the
wing cradle mount (1, Figure 37).
NOTE: Make sure the wing cradle is positioned with
the four front mount holes towards the front.
2. Raise the wing cradle and position the wing cradle
over the hitch frame cradle mount (2).
3. Lower the wing cradle and align the top holes of the
wing cradle with the holes in the hitch frame cradle
mounts.
4. Install four 5/8" x 2-1/2" bolts (3), 5/8" lock washers,
nuts (4) on each side and tighten
Figure 38
2
1. Install the wing stop rubber pad (1, [Figure 38]) on
the wing stop plate.
1
3 FOUR
MOUNT
HOLES
B-17022
1
Assembly - High Speed Compact Disc
2. Install four 3/8" x 1-1/2" bolts (2) and flat washers
through the pad and mount.
3. Install lock 3/8" washers, 3/8" nuts on each bolt and
tighten.
Repeat procedure for the LH wing stop.
Figure 39
3
1. Install the 1/2" x 2" bolt (1, Figure 39) wing lock arm
(2) and 1/2" lock nut (3) in the lower hole on the front
of cradle.
2. Tighten bolt and lock nut, do not over tighten, wing
lock arm must be able to rotate.
3. Install the 1/2" x 1-1/2" lock pin (4) and hitch pin (5) in
the upper cradle hole.
Repeat procedure on the LH side.
5
4
1
2
B-17035
39