Farm King HS8525 Operator And Parts Manual page 49

4. Raise the rockshaft slowly aligning the bolts with the
bearings until the two bearing castings fully contact
the rockshaft bearing mounts.
Figure 72
1
5. Install the two smaller bearing castings (1, Figure 72)
onto the bearing liners.
6. On the front side of the bearing casting install a bolt
up through the bottom of the bearing castings (both
sides). Install a 3/4" lock washer and 3/4" nut (2) (both
sides).
7. At the back of the of the rockshaft remove the bolt 3/
4" x 7" bolt (3) previously installed and reinstall the
bolt up through the bottom of the bearing casting
(both sides).
8. Install 3/4" lock washers and 3/4" nuts at the top of
each bearing mount (both sides). Tighten bolts.
2
3
1
B-17112
Assembly - High Speed Compact Disc
Figure 73
1. With straps and proper lifting device raise the cage
roller arm (1, Figure 73) up and align with the
attachment rockshaft mount as shown.
2. Install the four 3/4" x 3" bolts (2) and lock washers and
nuts. Do not tighten bolts at this time.
Repeat procedure on opposite end (3).
Figure 74
NOTE: Make sure the shaft (1, Figure 74) (both sides)
on the cage roller is free of paint and debris
before bearing installation.
3
2
1
B-17073
1
B-17115
49