Disc Arm / Blade Assembly - Farm King HS8525 Operator And Parts Manual

Figure 50
3
1
3
B-17051
1. Attach straps and / or proper lifting device to the RH
wing rear tube (1, Figure 50).
2. Position the RH wing rear tube as shown under the
RH wing frame (2).
3. Raise the RH wing rear tube up and align the three
mounts (3) to the three mounts on the RH wing frame.
4. Install four 3/4" x 2-1/2" bolts (4) down through the RH
wing frame mount holes.
5. Install 3/4" flat washers and 3/4" flange nuts on the
bolts. Do not tighten at this time.
Figure 51
2
1
35 mm
"
(1-3/8 )
6. Adjust the RH rear tube (1, Figure 51) 35 mm (1-3/8")
from the end of the center frame rear tube (2).
2
TOP VIEW
4
B-17098
Assembly - High Speed Compact Disc
7. Tighten the four bolts on each mounting tube mount.
Repeat procedures Figure 50 and Figure 51 for the LH
wing rear tube.

Disc Arm / Blade Assembly

Blade spacing on front and rear rows is 254 mm (10"),
with rear blades offset to front blades by 127 mm (5").
Figure 52
Rear Disc Arms
All front disc arms will angle to the left and all rear disc
arms will angle to the right as shown from rear view
(Figure 52).
REAR
Front Disc Arms
B-17070
43