Installing The Attachment Rockshafts And Cage Rollers - Farm King HS8525 Operator And Parts Manual

Figure 68
1
1. Install the hub / spindle (1, Figure 68) assembly into
the rockshaft.
2. Align the bolt hole and install the 1/2" x 5-1/2" bolt (2)
through the rockshaft tube and spindle.
3. Install a 1/2" lock nut (3) on the bolt and tighten.
Figure 69
1
4. Align the wheel (1, Figure 69) with the hub / spindle
assembly, with valve stem (2) facing outward.
5. Install ten 3/4" flange nuts (3).
6. Tighten wheel nuts in a criss-cross pattern to correct
torque (see Wheel Bolt Torque on page 158).
Repeat Figure 65 through Figure 69 procedures for the
RH wing rockshaft.
48
1
2
2 3
B-17095
2
3
B-17096
Assembly - High Speed Compact Disc
Installing The Attachment Rockshafts and Cage
Rollers
Figure 70
1
1. Install the bearing liners (1, Figure 70) and place the
large half of the bearing castings (2) on top of the
bearing liner (both sides).
Figure 71
NOTE: The LH and RH attachment rockshafts are the
same.
2. With straps and proper lifting device raise the
attachment rockshaft up and align with the rockshaft
mounts located on the wing.
3. Install a 3/4" x 7" bolt in the back hole of the rockshaft
bearing mount (1, Figure 71) (both sides) down
through each bearing half (2).
2
1
B-17081
1
2
B-17082