Installing Wing Rockshafts - Farm King HS8525 Operator And Parts Manual

Installing Wing Rockshafts

Figure 65
3
1
1
2
1. Install two bearing liners (1, Figure 65) onto the LH
wing rockshaft between the tabs on each end.
2. Place the two large halves of the bearing castings (2)
on top of the bearing liners.
3. Install a 3/4" x 7" bolt (3) in the hole of the rockshaft
bearing mount (both sides) down through each
bearing half.
4. With a proper lifting device, raise the LH wing
rockshaft slowly aligning the bolts with the bearings
until the two bearing castings fully contact the
rockshaft bearing mounts.
Figure 66
2
1
1
5. Install the two smaller bearing castings (1, Figure 66)
onto the bearing liners.
2
1
B-17103
4
3
2
1
B-17092
Assembly - High Speed Compact Disc
6. On the backside of the bearing casting, install a 3/4"
x 7" bolt (2) up through the bottom of the bearing
castings (both sides).
7. Install 3/4" lock washers (3) and 3/4" nuts (4) at the
top of each bearing mount (both sides).
Figure 67
5
2
1
8. Remove the two bolts previously installed and
reinstall the two bolts (1, Figure 67) up through the
bottom of the bearing casting.
9. Install lock washers (2) and nuts (3) at the top of each
bearing mount. Tighten bolts.
10. With a strap and proper lifting device attached to the
wing rockshaft, raise the wing rockshaft and align with
the rod end of the hydraulic cylinder.
11. Install the 1-1/4" x 7-3/8" cylinder pin (4) and cotter pin
(5).
4
3
2
2
1
B-17092
47