Farm King HS8525 Operator And Parts Manual page 86

Folding: Field Position to Transport
Wing and center frame fold cylinder hydraulic controls
should be in float from field operation.
1. Fully lift the frame out of the ground by fully
extending and phasing out hitch frame rockshaft
lift cylinders.
2. Ensure wing fold cylinder hydraulic control is in
float position.
3. Retract center frame fold cylinders until it appears
the wings are sitting vertically above the wing
tires.
4. Retract wing fold cylinders until both wings are
completely folded.
5. Retract the center frame fold cylinders the
remainder of the stroke to rest the wings in the
hitch cradles.
6. Place tractor in Park and exit operator's position
(see Leaving The Operator's Position on page 79).
Figure 145
7. Close all hydraulic lock-up valves (1, Figure 145)
prior to transport.
86
1
1
1
B-17119
Operation - High Speed Compact Disc
Figure 146
8. Remove the quick release pin (1, Figure 146).
9. Install all hitch frame rockshaft lift cylinder depth
stop plates (2) (both sides) for safety.
10. Install quick release pin (1).
NOTE: When transporting the equipment, all depth
stop plates on the hitch frame rockshaft
cylinders must be under the clevis back as
shown Figure 146. This will prevent the unit
from moving down if a hydraulic hose fails
when in transport.
Figure 147
11. Position hitch cradle wing locks (1, Figure 147) in
the lock position for transport.
12. Move to the operator's position (see Entering The
Operator's Position on page 79).
2
1
B-17123
1
B-17141