End Shield Assembly
Figure 61
2
End shield leg (1, Figure 61) and mount bracket (2) is
installed on the LH outer wing.
Figure 62
2
1
1. Install the end shield tube (1, Figure 62) as
shown and four 5/8" x 2" bolts (2)
2. Install 5/8" lock washers and 5/8" nuts on the bolts,
adjust end shield tube to desired position and tighten
bolts.
46
Figure 63
3
4
1
B-17087
3. Raise the end shield leg (1, Figure 63) up to the end
shield tube and install two rubber inserts (2).
4. Place the mounting bracket (3) and two rubber inserts
(4) at the top.
5. Install four 5/8" x 2-3/4" bolts (5) through the mount
bracket down through the end shield leg.
6. Install four 5/8" lock washers and 5/8" nuts on each
bolt. Tighten bolts.
Figure 64
1
B-17089
7. Install the end shield (1, Figure 64) on the inside of
the leg (2).
8. Install three 1/2" x 1-3/4" bolts (3) through the end
shield and leg. Install lock washers (4) and nuts
(5).Tighten bolts.
Assembly - High Speed Compact Disc
5
2
1
2
B-17087
5
3
4
B-17090