Farm King HS8525 Operator And Parts Manual page 85

Unfolding: Transport to Field Position
1. Move to the operator's position, start the engine
and release the parking brake (see Entering The
Operator's Position on page 79).
2. Move the tractor / equipment to the starting point
of the work area.
3. Stop the tractor and leave operator's position (see
Leaving The Operator's Position on page 79).
Figure 143
1
1
4. Open the hydraulic lock-up valves (1, Figure 143)
Figure 144
5. Unlock wing locks (1, Figure 144) on hitch cradle.
6. Use the tractor's hydraulic controls to ensure the
7. Extend center frame fold cylinders enough for the
8. Extend wing cylinders until both wing tires sit fully
9. Place the wing cylinder hydraulic control in the
10. Extend the center frame fold cylinders until the rear
11. Place the center frame fold cylinder hydraulic
1
12. Place tractor in Park and exit operator's position
13. Install the desired amount of depth stops per blade
NOTE: Ensure that each side of the hitch rockshaft lift
B-17120
14. Move to the operator's position (see Entering The
15. Lower hitch rockshaft cylinders until resting on
NOTE: Wing lift / fold cylinders and center frame fold
NOTE: The wing lift / fold cylinders must also be in
1
B-17140
Operation - High Speed Compact Disc
center frame lift cylinders are fully extended. See
the tractor's owner's manual.
wings to clear the hitch cradles.
on the ground.
float position.
rollers sit fully on the ground.
control in the float position.
(see Leaving The Operator's Position on page 79).
depth guide (see Blade Depth Guide on page 158).
cylinders receives the same amount of depth
stops.
Operator's Position on page 79).
depth stops and begin field operation.
cylinders must be in float mode when operating
in the field.
float mode when moving between transport
and field positions or between field position
and transport.
85