Programming Contact Id, Sia And Sms - Pyronix PCX-256 Programming Manual

PCX 256 PROGRAMMING MANUAL
key. ARC Details will be displayed. Repeat
the above for any other ARC stations you are
using. Press the
Calls?' will be displayed, press the
Program Digi Channels
Press the key to check that the Digi
Channels are what the ARC are looking for.
The first Digi Channel will be shown, once you
have checked this is correct, press the
to move to the next.
To change this channel please see page 38 for
the output types. All default values are shown on
page 58. Once you have completed all the Digi
Channels, 'Program Digi Channels will be
displayed'. Press the
'Program SMS Details' will be displayed and
Press the key.
3 Way Calling
Enter : for No (Default)
Enter : for Yes
Press the key. You will be returned to the
Engineer Menu.

5.23.3 Programming Contact ID, SIA and SMS

The Contact ID, SIA and SMS signalling protocols can also be used. However the programming
differs from Fast Format, here you have to select fixed content types (as opposed to programmable
outputs) you would like to be sent to the ARC. The table below shows all the content types.
Content Types
01 Arm
02 Disarm
03 Special Disarm
04 Arm Fail
05 Alarm
06 First alarm
07 Alarm Silenced
08 Confirmed
09 LoTechFault
10 HiTechFault
11 Tech Info
12 Manager Info
13 Engineer Info
14 AccessC Alarm
15 AccessC Info
16 AccessC Ref
Page: 60
key. 'Program Digi/SMS
key.
key.
All arm events (by area/level & user name)
All disarm events (by area/level & user name)
Disarm events initiated by codes 15 to 20 only
Attempt to arm the system failed
All alarm events (by partition, level and type) inc. code guess (excludes
tampers and emergency input types)
First to alarm event (for each input) only
Any alarm/fault silenced (by partition)
Sequentially confirmed alarm
Telecom Line restore (STU/ATE or DigiModem)
Low volts, Battery fault/OK, Fuse failure, RS-485 or Device Failure
System restart, Over current, Logs cleared
Code changed / deleted
Engineer accessing system, and leaving
Access Control door forced or left open
Access Control tag at Reader
Access refused (invalid code)
key
RINS868-6