Change Codes (Duress /Guard Only ); Code Types And Numbers; User Types - Pyronix PCX-256 Programming Manual

PCX 256 PROGRAMMING MANUAL
Exit Modes
Using the and
MODES? Press the
Enter : for Timed (Default)
Enter : for Final Door
Enter : for Timed/Final
Enter : for Push To Set
Press the key. Repeat for each partition or
press the key to return to the Engineer
Menu.
5 . 1 2 C h a n g e C o d e s ( D u r e s s / G u a r d O n l y )
All codes may be 4, 5, or 6 digit or proximity tags. Using a 5 or 6 digit code will automatically block
several possible 4 digit codes that clash with it. Please note that the PCX System will only comply
with Grade 3 if you have "5 digit codes" enabled (this is enabled at default). NOTES: Only Duress
or Guard codes can be changed by the Engineer, Normal user codes can only be changed
in The Manager Mode. The Master User and Engineer Codes cannot be deleted.

5.12.1 Code Types and Numbers.

PCX System
PCX 256

5.12.2 User Types

User Type Functions
User Arm and Disarm System. Also for Access Control and
Sub Partition Control functions
Default: 1234
Manager Arm and Disarm System
Also access to Manager menu functions
Master Manager Arm and Disarm System.
Default: 5678 Also access to Manager menu functions
Engineer Access to all engineering functions; also arm/disarm
system for test purposes.
Default: 9999
Disarm system, generating silent 'Duress' or 'Hold Up'
Duress
signal. NOTE: ACPO policy prevents use of duress codes
to police all purposes.
Guard Disarm system, but only after an alarm has been
active for a minimum time (programmable). Also arm
system. An output type is available to signal whenever
this code is used.
Page: 32
V i s u a l K e y p a d P r o g r a m m i n g P r o c e d u r e
E X I T M O D E S
keys, scroll to 'EXIT
key
User/Manager Codes
500
Duress/Guard Codes
20
Operation
Programmed by
Manager only.
Programmed by
Manager only.
Programmed by
Manager or Engineer.
Programmed by
Engineer.
Programmed by
Engineer.
Programmed by
Engineer.
RINS868-6