Options; Site Option Types - Pyronix PCX-256 Programming Manual

Intelligent Arm
Using the and
'INTELLIGENT ARM?' Press the
Intelligent
Enter : for No (Default)
Enter : for Yes
Press the key.
Use the numeric keys to select the input(s) that
will cause Intelligent Arming to occur. Press the
key. You will be returned to the Engineer
Menu.
5 . 1 7 S i t e O p t i o n s
A full range of site options is available to tailor the operation of the system.

5.17.1 Site Option Types

Option Default
Arm With Fault
Arm With
Tamper+
Arm With ATS
Fault
Arm With Part
TFault
Arm Fail =
Alarm
Do Bat Load
Test
Part
Misoperation
Strobe
Confirm
RINS868-6
V i s u a l K e y p a d P r o g r a m m i n g P r o c e d u r e
I N T E L L I G E N T A R M
keys, scroll to
key
Function
If 'YES': Allows arming with the following faults active: Device fail,
Yes Mains fail, Battery faults, Fuse faults, SMS failure, relay sirens
1&2, STU/ATE Strobe faults.
If 'YES': Allows arming with the following faults active: Case
No
tamper and System tampers.
If 'YES': Allows setting with the following faults active: Telecom
Yes line fail, Modem failed, STU/ATE line fault, STU/ATE one path fail,
Digi dial fail, STU/ATE comms fail.
If 'YES': Allows a sub-partition to be armed if mains, battery,
Yes
telecom line, or other system fault is present.
If 'YES' = A graduated alarm will be generated when 'Arm Fail'
timer expires (see Change Timers), if exit procedure is still
No
incomplete. Arm fail output will trigger.
If 'NO' = Exit time will continue until the Exit route is clear.
If 'YES': Programmes the system to perform a full load test of the
No
battery at 7.00am each day.
If 'YES' Allows a Misoperation (Abort) signal to be generated
No without the entry of a valid code into the system when sub-
partition is operated after an alarm.
If 'YES': A 'STROBE ANY' output will be activated for 5 seconds
No as the system arms. Use with care, in view of potential security
risk.
PCX 256 PROGRAMMING MANUAL
Page: 45