Stu / Ate Pin Outputs (Defaults); Pcx-Prox/Ext Pgm Output - Pyronix PCX-256 Programming Manual

5.15.2 STU / ATE Pin Outputs (Defaults)

Any communicating device with the industry standard footprint may be plugged onto the control
panel STU / ATE (Alarm Transmission Equipment) pins. The default types for the footprint are as
follows:
COM LOOM
1 (Blue)
2 (Orange)
3 (Yellow)
4 (Brown)
5 (Purple)
6 (Green)
7 (Black)
8 (Purple)
9 (White)
10 (Light Grey)
NOTE: There is an "Invert ATE outputs" option for use with positive removed signalling.
Insufficient current is available for any other application. Please see 'Site Options, page 47.
These are programmed in 'Change Outputs' under 'Endstation PGMs'.
For programming of the onboard Digi channels please see page: 58.

5.15.3 PCX-PROX/EXT PGM Output

The RED LED on the PCX-PROX/EXT can be programmed so that it follows an output.
To achieve this, go to 'CHANGE OUTPUTS' and then 'Reader PGMs' and program the first PGM
output (PGM1) to whichever type is required.
For example you may want the Prox to show the system armed, therefore you can use the output
"0204: Final Arm A". The RED LED will then be illuminated once Partition A has armed.
Change Outputs
Using the and
OUTPUTS?' Press the
Endstation PGMs
To program the control panel PGMs and the
STU/ATE pins press the
RINS868-6
Default Type
Fire
HU Device Any
Unconfirmed Any
Final Arm Any
Tamper Any
Confirmed Any
Omit Rearm Any
AC Fail
Global Fault 2
Test ATS
V i s u a l K e y p a d P r o g r a m m i n g P r o c e d u r e
C H A N G E O U T P U T S
keys, scroll to 'CHANGE
key
key.
PCX 256 PROGRAMMING MANUAL
PGM Number
0001
0009
0018
0022
0007
0006
0017
0052
0056
0064
Page: 41