Set Time And Date; Exit Modes; Timed; Final Door - Pyronix PCX-256 Programming Manual

Change Timers
Using the and
TIMERS?'
Press the key
Timers
The timers as displayed in the table on the
previous page will be displayed, adjust the time
as required and press the
have finished, press the
returned to the Engineer Menu.
5 . 1 0 S e t T i m e a n d D a t e
All log entries and the system display include the time and date. This may be also programmed in
the Master Manager Mode. NOTE: Please note that powering down the system will reset the
time and date information.
5 . 1 1 E x i t M o d e s
The 'Exit Modes' operate the arming procedure of the PCX system. The following Exit Modes are
available:

5.11.1 Timed

The PCX system will only arm when the programmed Exit Time has expired (See 'Change Timers'
page 31) providing that all inputs are closed. NOTE: This is NOT suitable for systems installed
to comply with DD243.

5.11.2 Final Door

The PCX system will only arm when an input programmed as Entry/Exit (EE) is either closed (if the
input was opened when arming started) or its single opening and then closing (if the input was
closed). This mode may also be used for 'lock arm' operation: securing the lock completes the
arming procedure, unlocking starts the entry time.

5.11.3 Timed/Final

This function follows 'timed' operation, except that the timer will be overridden if an Entry/Exit input
is opened and closed before the timer expires (See above: Final Door). NOTE: This is NOT
suitable for systems installed to comply with DD243.

5.11.4 PTS (Push To Set)

PTS = Push to Set. The PCX system will only arm when a 'Push to Set' button has been pressed.
This function will override the programmed Exit Time.
RINS868-6
V i s u a l K e y p a d P r o g r a m m i n g P r o c e d u r e
C H A N G E T I M E R S
keys, scroll to 'CHANGE
key. Once you
key, you will be
PCX 256 PROGRAMMING MANUAL
Page: 31