Pyronix PCX-256 Programming Manual page 40

Type
0020 Exit Starts All
NOTE: For 'exit starts' to be entered in system logs, the site option 'Confirmed when...' must
be set to 'exit start'
0021 Exit Starts Any
Final Arm Any
0022
(Open / Close)
0023 Strobe Set Fail
Keyswitch
0025
Disarm
0031 Entry
0032 Exit
0033 Entry/Exit
0034 Lights
Follow Input
0035
See page: 43.
0036 Shunt Fault
Reset 1 (Viper
0037
Reset)
Reset 2 (Viper
0038
Arm/Disarm)
0039 PIR Latch 1
0040 PIR Latch 2
0041 Mains Good
0042 Detr Indn Enable
0043 Follow Test
0044 Off During Test
Telecom Line
0051
Fault
0052 AC Fail
0053 Battery Faults
0054 Low Volts
Global Fault 1
0055
(Grade 2)
Global Fault 2
0056
(Grade 3)
0057 German Relay
Guard Code
0058
Used
RINS868-6
Defaults Active
Also once entry time has
started
At start of exit time to arm
LAST partition
When exit time starts to arm
FIRST partition
ATE 4
When ANY partition is armed
DIGI 4
Works similar to output 016, but also fires if the set fail
timer expires.
This output turns on for 5 seconds when the system is
disarmed via a keyswitch input (either pulsed or latched
keyswitch)
Live during any exit time
Live during any entry time
Live during any entry or exit time
When exit or entry timer
starts
When input triggers
At code entry to arm
At code entry to arm
Re-triggers whenever an additional partition is armed
When armed (and in Walk
PGM 1
Test)
This is the inverse polarity to PIR Latch 1
Output showing the mains is healthy
This output activates during walk test and also when a
code is entered to view indications – staying activated for
the time for which the indications are viewed.
New output for bell test by activating SAB
New output for bell test by activating SAB
When Line Fault signalled by
communicator
ATE 8
After pre-set time without
mains power
DIGI 13
When battery disconnected
or load fail detected
At fault
Activates if input fault occurs
only when system is armed
ATE 9
Activates if input fault occurs
at any time
DIGI 9
When 'guard' code accepted
PCX 256 PROGRAMMING MANUAL
Restore
At code entry to disarm
FIRST partition (i.e. no
longer fully armed)
At code entry to disarm
LAST partition
At code entry to disarm
LAST partition
20 seconds after
arm/disarm procedure
completed
Dependant upon
programming
See Shunt Inputs - Page: 21
After 3 seconds
When disarmed
At alarm, or when
disarmed
When fault clears
On restoration of mains
At next valid code entry
When fault clears
When all faults cleared
When all faults cleared
Not applicable for UK installations
After 60 seconds
Page: 39