Set U P Downloading; Download By; Security Mode - Pyronix PCX-256 Programming Manual

The status of the inputs will be shown.
C = Closed. O = Open. F = Fault (Tamper)
Press the key.
The circuit resistance will be shown on any on
the inputs you choose (enter the input number).
OC: Open Circuit, CC: Closed Circuit
DF: Detector Fault, DM: Detector Masked
Press the key.
Enter a RIX address and repeat the above for
the RIX inputs. Press the
keypad and reader inputs. Press the
'View Inputs' will be displayed, press the
key.
If you would like to calibrate the PSU voltage of
the PCX system, Press the
. Place a calibrated volt
meter across the battery connectors (with the
battery disconnected) or across the auxiliary
terminals and use the
reach the desired voltage (13.7V is the
recommended value). Press the
will be returned to the Engineer Menu.
5 . 2 2 S e t U p D o w n l o a d i n g
The PCX system has uploading and downloading capability. The PCX UDL Software allows you to
monitor the status of each input, alter programming, and review the logs.
There are two ways that the panel communicates with the PC, one is remotely; via the telephone
line (thus you will require the digi modem card (PCX-DIGI+ARM) and the other is directly; by using
an RS232 lead (PCX-RS232L) which connects into the PCX 256 expander card and your PC.

5.22.1 Download By

Select either RS232 (direct connection) or Modem (remote dial in connection). The default is None.

5.22.2 Security Mode

This function allows you to choose a range of dialling modes that can be used:
Auto Answer: permits the PC to dial into the panel. (Default)
Dial Back: permits the PC to dial the panel, which hangs up the call and dials the PC back to
establish communication.
Panel Dials: does not allow the PC to dial into the panel at all.
All modes allow the panel to dial the PC without restriction. At any time, the panel can be forced to
dial the PC by entering the Manager menu and selecting the Dial Out Menu. Please see page 64.
RINS868-6
key. Repeat for the
key.
key and enter
and until you
key. You
PCX 256 PROGRAMMING MANUAL
Page: 55