Resetting The Adapter - Allen-Bradley PowerFlex 20-COMM-P FRN 1 Series User Manual

3-6 Configuring the Adapter

Resetting the Adapter

Changes to switch settings or some adapter parameters require that you
reset the adapter before the new settings take effect. You can reset the
adapter by cycling power to the drive or by using the following
parameter:
ATTENTION: Risk of injury or equipment damage exists. If the
adapter is transmitting control I/O to the drive, the drive may fault when
!
you reset the adapter. Determine how your drive will respond before
resetting a connected adapter.
• Set the Parameter 08 - [Reset Module] to Reset Module:
Figure 3.4 Reset Screen on an LCD HIM
Port 5 Device
20-COMM-P
Parameter #: 8
Reset Module
Reset Module
When you enter 1 = Reset Module, the adapter will be immediately
reset. When you enter 2 = Set Defaults, the adapter will set all adapter
parameters to their factory-default settings. The value of this parameter
will be restored to 0 = Ready after the adapter is reset.
1
Value Description
0 Ready (Default)
1 Reset Module
2 Set Defaults