Table of Contents
Advertisement
1. Press the m button repeatedly until
the mode you want (
FM
-
AM
-
TV
) is highlight-
ed.
2. Press the i button or touch the tab of
the same name in the header.
3. Select "
Preset memory
".
The available preset memories are listed.
4. Select the preset memory you want.
5. Touch the m tab in the header again.
If you briefly touch the preset memory dis-
played in the main menu, you will likewise
switch to another preset memory.
Choosing a station in the station list and
storing it
1. Press the m button repeatedly until
"
FM
" is displayed.
2. Select "
Station list
".
3. Select the station entry you want by pressing
and holding it for several seconds.
The station buttons are displayed and the sta-
tion previously chosen is shown in the informa-
tion window.
4. To store the station on a station button, select
the station button you want.
The station list is displayed again.
24
TUNER
Storing via an automatic station search
(autostore)
The automatic station search is only available for
the preset memories
FM 1
,
FM 2
,
FM 3
as well as
AM 1
AM 2
AM 3
,
and
.
1. Press the m button repeatedly until
FM
AM
TV
the mode you want (
-
-
) is highlight-
ed.
2. Set the preset memory if applicable
(> page 23).
Autostore
3. Press and hold the "
" menu item.
The search is activated. It stores the six sta-
tions with the strongest reception and tunes to
the strongest station.
Storing stations manually
1. Press the m button repeatedly until
the mode you want (
FM
-
AM
-
TV
) is highlight-
ed.
2. Tune to the station (> page 22).
3. Set the preset memory if applicable
(> page 23).
4. Press and hold the station button for a few sec-
onds.
As soon as the station is stored on the station
button, the station name or the station frequen-
cy is displayed on the button and you hear a
signal tone.
Traffic programme (TP)
Various FM radio stations broadcast traffic mes-
sages in addition to their radio programmes.
The broadcasting stations are responsible for the
quality of these traffic messages. For that reason,
no liability can be accepted for the completeness
and correctness of the information.
Traffic messages are part of the RDS signals and
are not available everywhere. To find out more,
please refer also to the sections "Switching RDS
on/off" on page 25 and "Displaying traffic mes-
sages (TMC)" on page 109.
Switching the traffic programme on
1. Press the m button repeatedly until
"
FM
" is highlighted.
Traffic prog.
2. Select "
" to activate ( ) or
deactivate ( ) the function.
When the traffic programme is switched on,
the abbreviation TP (Traffic Programme) is dis-
played in the bottom line and you hear the traf-
fic messages regardless of the audio source
that is currently active.
Advertisement
Chapters
Table of Contents
