Table of Contents
Advertisement
Closing the rear view camera display
The rear view camera display is closed again as
soon as you:
– disengage reverse gear (after 30 seconds or a
speed of > 15 km/h (approx. 9.5 mph)),
– press one of the main menu buttons,
– press the Back button h,
– operate the electric parking brake or
– move the Porsche Doppelkupplung (PDK) gear
selector into the P position.
Switching grid lines for the rear view
camera on/off
No grid lines are displayed in the following sit-
uations:
– manual activation of the rear view camera
display,
– driving forwards,
– open tailgate or
– trailer detected.
If your system is not calibrated or there is a
steering angle sensor error, please visit a Por-
sche workshop.
1. Press the w button.
2. Press the i button or touch the tab of
the same name in the header.
3. Select "
SET CAR
"
> "
SET parking
".
4. Select "
RVC grid lines
" to activate ( ) or
deactivate ( ) the function.
Parking with the rear view camera display
1. Engage reverse gear.
2. Turn the steering wheel so that the grid lines
guide you into the parking space as accurately
as possible.
3. Drive backwards carefully until the edges of
the blue parking aid are parallel to the parking
space.
4. Turn the steering wheel to straighten up while
the vehicle is stationary. Drive until the end of
the lower edge of the blue parking aid is posi-
tioned at the end of the parking space.
If the ground is uneven, the display of the grid
lines may differ from the actual lane.
WARNING!
Accident hazard. If the grid lines touch or in-
tersect obstacles, there is a risk of collision.
û Make sure that there are no people, ani-
mals or obstacles within the manoeuvring
area.
Accident hazard. If the ground is uneven, the
road is slippery or the vehicle is on an incline
(e.g. curb, hill) the actual lane may differ from
the precalculated grid lines.
û Continue to pay attention to the complete
area behind the vehicle.
Picture settings for the rear view camera
Setting the Brightness
1. Press the w button.
2. Press the i button or touch the tab of
the same name in the header.
3. Select "
SET CAR
"
> "
SET parking
"
RVC picture param.
> "
"
> "
Brightness
".
CAR
117
Advertisement
Chapters
Table of Contents
