Appendix D: Rs-232 Interface; Communication Configuration Settings; Custom Cable Information - Teledyne Everywhereyoulook IsoPlane 320A Manual

Appendix D: RS-232 Interface

This appendix provides information necessary when using the RS-232 interface for
communication between the host computer and an IsoPlane system.
D.1 Communication Configuration Settings
When using RS-232 for communication with the IsoPlane spectrograph, the RS-232 port on
the host computer system must be configured as follows:
D.2 Custom Cable Information
This section provides the information necessary to build a custom RS-232 cable to be used
with an IsoPlane spectrograph.
Figure D-1: DB9 Connector Pinout
Table D-1
IsoPlane spectrograph.
9600 Baud;
•
8 Data Bits;
•
No Parity;
•
1 Start Bit;
•
1 Stop Bit.
•
provides the pinout information for an RS-232 cable that is to be used with an
NOTE:
The pinout information in
diagram since this cable is a straight through cable.
1
6
2
7
3
8
4
9
5
R /C V
EAR ABLE IEW
Table D-1 also serves as a wiring
71