Advertisement
Evaporation Instruction Sheet
60-5272-001
General Safety Instructions
The device has been constructed according to state-of-the-art
technology and recognized safety regulations. However, risks
may still arise during installation, operation and maintenance.
Please ensure the operating manual is available at all times.
The device may only be used under the following circumstances
•
Only operate the device, if it is in full working order.
•
Ensure all operators of the device possess the necessary
safety and risk awareness.
•
Operate the device according to the instructions stipulated
in this manual only.
•
If there is something you do not understand, or certain infor-
mation is missing, ask your manager or contact the manufac-
turer.
•
Do not do anything on the device without authorization.
•
Only use the device according to its intended use.
Intended Use
The device is intended for use by trained and authorized person-
nel only. The device is suitable for the following:
•
Economical cooling as alternative to tap water systems use.
•
Research application.
Improper Use
Any use which deviates from the device's intended use is consid-
ered to be improper. The manufacturer does not accept liability
for any damages resulting from non-permitted uses. The risk is
carried by the operator alone.
Installation/Electrical Safety
•
The device may only be connected when the main voltage
corresponds to the information on the type plate of the unit.
•
The main connection must be accessible at all times.
•
Repairs may only be performed by a qualified electrician.
•
Never operate the unit with a damaged power cord.
•
Always turn the unit OFF and disconnect main power before
performing any maintenance or service.
Personnel Qualification
•
The device may only be operated by qualified persons.
•
The device may only be operated by individuals who have
been instructed in its proper use by qualified persons.
•
The device may only be operated and maintained by per-
sons who are of legal age.
•
Other personnel may only work with the unit under continu-
ous supervision of an experienced qualified operator.
•
This manual must be read and understood by all persons
working with the device.
•
The personnel must have received special safety instructions
in order to guarantee responsible and safe work procedures.
EAR99 Technology Subject to Restrictions Contained on the Cover Page
Operating Company's Obligations
Installation Site
•
The device must be positioned in a suitable location.
•
The device must be installed sufficiently stable on a strong
and level surface.
•
All screw connections must be securely tightened.
•
The device should be located as close as possible to the
process requiring cooling.
•
The device should not be installed closer than 1.4 meters
(4 feet) to a heat-generating source, such as heating pipes,
boilers, etc.
•
If possible, the device should be located near a suitable drain
to prevent flooding in the event of leaks.
•
Do not place the device where corrosive fumes, excessive
moisture, excessive dust, or high room temperatures are
present.
•
The site must have an 80% relative humidity and tempera-
ture between 5–35 °C
•
Adequate clearance should be allowed on the front, sides,
top, and rear of the device for access to connections and
components.
•
The front and side vents of the device must be a minimum
of 21 cm (8 inches) away from walls or vertical surfaces, so air
flow is not restricted.
Changes to the Unit
•
No unauthorized changes may be made to the unit.
•
No parts may be used which have not been approved by the
manufacturer.
•
Unauthorized changes result in the EC Declaration of Confor-
mity losing its validity, and the appliance may no longer be
operated.
•
The manufacturer is not liable for any damage, danger or
injuries that result from unauthorized changes or from oper-
ating the unit other than described in this manual.
Advertisement
