Operator Numbering; Batch Numbering; Serial Numbering; Send Results To Server - Voltech AT5600 User Manual

C H A P T E R 1 4 - A T
O p e r a t o r N u m b e r i n g
During program execution, the operator will be prompted to enter his or her
identity code. All server results will then be tagged with this code.
B a t c h N u m b e r i n g
During program execution, the operator will be prompted to enter a batch number,
which will be attached to the server test results.
S e r i a l N u m b e r i n g
During program execution, the operator will be prompted to enter a serial number
for each transformer (or you can select auto-increment). The number will then be
attached to the server results for the next transformer tested.
S e n d R e s u l t s t o S e r v e r
Select this option if you wish to have the tester send all the measurement results
back to the Server PC for archive or analysis.
S e n d R e t r y R e s u l t s t o S e r v e r
Enable this function if you wish the Server archive to contain the results from the
additional measurements associated with re-running a program, for example after
execution has been halted by the STOP ON FAIL program option.
AT5600 User Manual 98-119 issue 14
E D I T O R
Page 285