Removing The Air Filters; Test Probes; Power Cords; Cleaning - Voltech AT5600 User Manual

C H A P T E R 1 1 – M A I N T E N A N C E
11.1.2.
The filters can be cleaned with water or suction using a vacuum cleaner.
11.2.

Test Probes

If any test probe gets damaged, they can be removed using needle nose pliers.
Grasp the test probe firmly using the pliers and pull straight up. The 3 mm test
probes are Ingun (UK) Ltd Part Number GK S113 204 300 R 1502.
The test pins on the bottom of the test fixture can also tarnish with age, and
accrue dirt and grease from the manufacturing environment.
Voltech recommends Chemtronics Pow-R-Wash VZ for cleaning the test pins/
https://www.chemtronics.com/pow-r-wash-vz
11.3.

Power Cords

Regularly check the power cord for any signs of wear and replace it if necessary.
11.4.

Cleaning

Clean only using a damp cloth.
Do not use any cleaning chemicals as damage may occur to surfaces.
Do not allow water to run inside.
Ensure surfaces are thoroughly dry before use
.
AT5600 User Manual 98-119 issue 14

Removing the air filters

Page 254