Remove Tub Front Panel - Mfr80 - Maytag MFR Series Service Manual

ReMOve TuB FROnT panel - MFR80

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Remove the front panel (See page 4-19).
2. Remove the lower service panel
(See page 4-12).
Door Lock
Connector
3. Disconnect the door lock connector from the
control board.
4. Clip the wire ties to release the wire harness
from the cabinet.
5. Mark tub front panel on both sides of door
and measure distance from the floor to each
mark. Record this right on the panel for
proper door alignment during reassembly.
Mark Beside
Door
6. Loosen, to the end of the bolt, both 13mm
nuts on both outer band clamps that secure
the tub front panel to the tub.
7. Support the tub front panel or it will fall off
when the band is removed.
8. Remove the band, then remove the tub front
panel with the door attached if it was not
removed earlier.
9. If the rubber seal does not come off with the
front panel, remove it from the tub as well.
6-46
Outer Band
Clamps