Remove & Replace Bearing Assembly - Mfr60 - Maytag MFR Series Service Manual

ReMOve & ReplaCe BeaRinG aSSeMBly - MFR60
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
excessive Weight Hazard
use two people to move or install
heavy parts.
Failure to do so can result in back or
other injury.
1. Open washer door, install basket stabilizer
tool, #518919, into the drum opening, this
tool keeps the basket centered and in
position while the trunnion is removed.
2. Remove the back panel (See page 4-28).
3. Use a pry board or bar to lift slightly on the
motor to release tension on the v-belts.
Remove v-belts while turning basket pulley
V-Belts
4. To remove the basket pulley, block it from
moving using the lever bar, #514759.
5. Use a 24mm socket or wrench to remove
the M16x30 bolt in the center of the pulley.
Basket
Stabilizer
#518919
6. Insert the M16 center bolt, #518942, into
the threaded hole of the shaft in the center
of the pulley. First, tighten it by hand, then
tighten the bolt by wrench until just a few
threads are left showing on the bolt.
6-35
Pry Board
Under Motor
Lever Bar
#514759
M16x30 Bolt
M16 Center
Bolt #518942