Tub Front Cover - Maytag MXR65 Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Remove the door support front plate.
(See page 3-44)
2. Pull the drip shield off which is installed with
double stick tape.
3. The three covers at the bottom are for
heater elements, which would have to be
removed if they were present.
Three
Covers
4. Mark tub front cover, clamp and tub to assist
in proper orientation during reinstallation.

TuB FRONT COveR

5. Measure from the base of the washer to the
6. Measure and mark a bolt on the other side
7. Loosen the 13mm nuts on both ends of top
8. Support the tub front cover.
9. Release the clamp and remove it from
10. Remove tub front cover from the washer.
11. There is a gasket around the entire edge
3-45
middle of a bolt on the tub front cover. Mark
the distance on the cover.
for proper orientation during reinstallation.
bolt clamp securing the tub front cover.
around the edge of the cover.
inside the cover.
Gasket