Diagnostics & Troubleshooting; Mfr30 - 80 Power Supply - Maytag MFR Series Service Manual

DiaGnOSTiCS & TROuBleSHOOTinG
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
pROpeR GROunDinG
anD pOlaRizaTiOn OF
120 vOlT Wall OuTleTS
FOR MFR18 & 25
All appliances have a three-prong power
cord and MUST be connected to a properly
polarized AND grounded wall outlet.
This information was written for those who do
not understand grounding and polarization
of a wall outlet. A 120 volt wall outlet must
always be wired as shown below.

MFR30 - 80 pOWeR Supply

The power supply required for all MFR30 - 80
washers is 208 - 240 VAC single phase.
The model serial plate will proclaim washers
will function with 3 phase power. 3 phase
power, when supplied to these washers, will
require that the third phase be connected to
the dead terminal on the terminal block. This
third phase should be the stinger phase when
it is part of the power supplied. The third
phase is not used by this washer. Splitting off
the third phase provides the needed single
phase power to the washer.
8-1