Section 3. Cabinet Assembly Components; Cabinet Body Assembly; Front Panel - Maytag Jenn-Air Service Manual

SECTION 3. CABINET ASSEMBLY COMPONENTS
The components that comprise the cabi-
net assembly of the washer consists of:
the cabinet body assembly, front panel,
rear access panel, top assembly, base
assembly, and the stabilizer assembly.
CABINET BODY ASSEMBLY
The cabinet body assembly consists of a
steel enameled "U"-shaped cabinet with a
reinforcement brace welded across the
upper front of the assembly.
/r.
~
·
.
·
·
.~
-
I,.-o!
•
r---
Locating Pin
--
·
·
r-=
~\.
~
~
IJ
The cabinet body assembly provides
mounting for the front panel, rear access
panel, top assembly, water mixing valve,
and the power cord.
The cabinet body assembly is attached to
the perimeter of the base with ten (10)
screws.
REMOVAL:
1. Disconnect the unit from the power
source.
2. Remove the top assembly as detailed
later in this section.
3. Remove the front panel as detailed
later in this section.
4. Remove the top hinges and power
cord.
5. Remove inlet hoses from water mix-
ing valve.
6. Remove rear access panel.
7. Remove water mixing valve.
8. Remove wiring clips and clamps
from inner cabinet rear.
9. Remove the screws that secure the
cabinet body to the perimeter of the
base.
10. Open the front of the cabinet body
slightly and push if off the rear of the
base.
Front Panel
The enamel,ed steel front panel is at-
tached to the cabinet body brace at the
top, and secured at the bottom with base
mounting clips. Locating pins on the
cabinet front flanges position the front
panel for assembly (see illustration on
the following page).
The front panel provides mounting for the
locating pins and top clips.
16007667
SECTION 3. CABINET ASSEMBLY COMPONENTS
3·'
©
1996 Maytag Corporation