Remove Door Lock - With Access Panel - Maytag MFR Series Service Manual

ReMOve DOOR lOCk - WiTH aCCeSS panel

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Open the washer door.
2. Remove two star head screws at the left of
the door opening.
3. Loosen two screws at the left of the front
panel.
2 Star Head
Screws
4. Lift the front panel out slightly and remove
the door lock assembly cover.
2 Star Head
Screws
Door Lock
Cover
4-23
5. Remove the two star head screws from the
lock assembly.
2 Star Head
Screws
6. Pull the door lock assembly out and
disconnect the wiring harness.
Shims
7. Make sure the shims are reinstalled with
the door lock. Use silicone to hold them in
place so they don't fall.
nOTe: If there is no door lock access
panel, See page 4-21.
Wiring
Harness