Remove Brake Resistor Mfr60 & 80 - Maytag MFR Series Service Manual

ReMOve BRake ReSiSTOR
MFR60 & 80
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Remove power from washer and wait 10
minutes before attempting any further steps.
Before working on a brake resistor, follow the
procedure for testing inverters
See page 7-7). This must be done anytime an
inverter or brake resistor is being worked on.
1. To remove the brake resistor, remove the
two bolts that secure the brake resistor to
the inverter bracket.
Two
Bolts
2. Disconnect the positive and PR wires from
the inverter.
3. Clip any wire ties necessary to release the
wires to the brake resistor.
4. Remove the wires from the feed through
and remove the brake resistor.
4-39
Positive (+)
Brake Resistor
Wires
PR