Details Of Profibus Connectivity; Profibus Dp Slave 6 E/Dc 24 V, 4 A/Dc 24 V/1A - Danfoss VLT DMS 300 Manual

Details of Profibus Connectivity

Profibus DP Slave 6 E/DC 24 V, 4 A/DC 24 V/1A

connection
supply power to the
module
supply power input and
output
galvonic isolation
Bus interface
MG.90.F2.22 - VLT is a registered Danfoss trademark
bus connection
termination
voltage range incl. ripple
ripple
current consumption
connection
voltage range incl. ripple
connection
isolation voltage
Bus system
module type
standard
data width in the process image
fieldbus controller
identifier
addressing
baud rate
Decentral Solutions
NOTE
When using Profibus interface, the complete
control of the DMS is done by the Profibus. The
DMS control terminals cannot be used.
spring terminal block 2 x 2 x 0.1 sq.in. (2.5
sq.mm.)
69: A-Line RxD/TxD-N, green wire 68:B-Line
RxD/TxD-P, red wire
switchable, SW2 both on
20-30VDC
max. 10%
nom. 90 mA
spring terminal block 2 x 2 x 0.1 sq.in. (2.5
sq.mm.)
201: DC 0 V, 202:DC 24 V
20-30VDC
spring terminal block 2 x 2 x 0.1 sq.in. (2.5
sq.mm.)
203: DC 0 V, 204:DC 24 V
DC 500 V between bus and electronics
DC 2.5kV between module supply and
inputs/ outputs
Profibus DP
Slave I/O module
DIN 19245
1 Byte inputs, 1 Byte outputs
LSPM2
0409 hex
Node ID: 1-99 set by DIP switch SW3
up to 12Mbaud, automatic detection
59