Table of Contents
Advertisement
Bit (Hex)
Extended status words
000001 Ramping
000002 AMT running
000004 Start forw./reverse
000008 Slow down
000010 Catch-up
000020 Feedback high
000040 Feedback low
000080 Output current high
000100 Output current low
000200 Output frequency high
000400 Output frequency low
002000 Braking
008000 Out of frequency range
Bit (Hex)
Alarm words
000002 Triplock
000004 AMT tuning fail
000040 HPFP bus timeout
000080 Standard bus timeout
000100 Curr. short circuit
000200 Switch mode fault
000400 Earth fault
000800 Overcurrent
002000 Motor thermistor
004000 Motor overload
008000 Inverter overload
010000 Undervolt
020000 Overvolt
040000 Phase loss
080000 Live zero error
100000 Heat sink temperature too high
2000000 Profibus communication fault
8000000 Inrush fault
10000000 Internal fault
Spare parts
The complete electronic part can be used as a spare
part. The following four parts can replace all FCD
303-330 with and without Profibus.
For servicing DeviceNet and AS-interface units
an additional control card is required to upgrade
the electronic spare part.
FCD 303 178B1484
FCD 307 178B1485
FCD 315 178B1486
FCD 330 178B2301
The parts can be downsized one size simply by selecting
the correct motor size, and the Profibus functionality
can be changed/eliminated in Parameter 678.
MG.90.F2.22 - VLT is a registered Danfoss trademark
Decentral Solutions
The control card can also be replaced for
repair of the electronic part.
Profibus, 12 MB control card 175N2338
DeviceNet control card 175N2324
AS-interface control card 175N2325
For servicing the installation box a kit containing
various parts, plugs, and terminal PCB can
be ordered 175N2121.
Service tool kit 175N2404
It is normally not possible to operate the FCD300 with
open lid. Using the service tool kit, the electronic part
and the installation box can be connected without
joining them. This might be helpful if measurements on
input/output terminals are required during servicing.
193
Advertisement
Table of Contents
