Table of Contents
Advertisement
Note: 0.1 Amps is added internally to the
value read from DIP switches.
Completing the installation:
To complete installation, fit the DMS Electronics
module to the DMS Installation box and secure with
the screws provided. Recommended tightening torque
for the screws is between 2.5 and 3 Nm.
52
Decentral Solutions
MG.90.F2.22 - VLT is a registered Danfoss trademark
Advertisement
Table of Contents
Need help?
Do you have a question about the VLT DMS 300 and is the answer not in the manual?