Table of Contents
Advertisement
EMC-correct electrical installation
General points to be observed to ensure
EMC-correct electrical installation.
- Use only shielded/armoured motor cables and
shielded/armoured control cables.
- Connect the screen to ground at both ends.
- Avoid installation with twisted shield ends (pigtails),
since this ruins the shielding effect at high
frequencies. Use cable clamps instead.
- Don't remove the cable shield between the
cable clamp and the terminal.
MG.90.F2.22 - VLT is a registered Danfoss trademark
Decentral Solutions
75
Advertisement
Table of Contents
Need help?
Do you have a question about the VLT DMS 300 and is the answer not in the manual?