Specifications And General Information; Specifications - Omron SYSMAC C Series Operation Manual

Specifications and General Information

5-1

Specifications and General Information

5-1-1 Specifications

General Specifications
Performance Specifications
Item
Number of analog inputs
Input signal
Voltage input
range (See range (See
Current input
note 1.)
Advanced functions
Resolution
Accuracy Voltage input
Current input
Conversion time (See note 2.)
Input p
Voltage input
impedance
Current input
Maximum input p Voltage
signal
Current
Reporting data format
Number of I/O words
PC communications
Internal memory
Front window indicators
Input connector
Vibration
Durability
resistance
Malfunction
Impact Durability
resistance
Isolation
Power consumption
Dimensions
Weight
62
All general specifications of the C500-AD501 Analog Output Unit conform to
those of the C Series.
16 points, differential
0 to 5 VDC, 0 to 10 VDC, –5 to 5 VDC, –10 to 10 VDC
0 to 20 mA, –20 to 20 mA
Scaling, alarms, averaging, filtering, peak hold. Select and configure per input point
1/4096 (12 Bit) 0.02%
±0.08% at 25°C
±0.15% over 0° to 55°C with 95%
±0.18% at 25°C
±0.25% over 0° to 55°C with 95%
*Includes internal 0.1% 250 Ω resistor
25 ms minimum, all 16 inputs
1 MΩ minimum
250 Ω
± 15 VDC
± 30 mA
Signed BCD
2's complement binary
Set from CPU Unit or serial port
2
I/O READ and I/O WRITE instructions
RAM
EEPROM for memory map storage
Run, error, range, comm error, transmit/receive
OMRON 38-terminal removable connector C500-PAR-PTC 38
10 to 54.8 Hz at 0.25 mm amplitude in X, Y and Z directions for 12 times in 10 min.
54.8 to 300 Hz at 3G in X, Y and Z directions for 12 times in 10 min.
10 to 61.2 Hz at 0.1 mm amplitude in X, Y and Z directions for 4 times in 8 min.
61.2 to 150 Hz acceleration at 1.5 G in X, Y and Z directions for 4 times in 8 min.
30 G in X, Y and Z directions three times each direction
Optical isolation between input terminals and PC: 1,500 VDC
1.2 A from Backplane; 6.2 W max.
34.5 x 250 x 120 mm (W x H x D)
700 g max.
Note 1. The input signal ranges are set using the DIP switches and slide switches.
2. Using special functions will increase the A/D conversion time.
Specification
Section 5-1