Basic Functions - Mercedes-Benz COMAND Online Supplement Manual

X
Insert the new batteries. Observe the polar-
ity markings on the batteries and battery
compartment when doing so.
Left-hand battery: The positive pole (+)
must face upwards.
Right-hand battery The positive pole (+)
must face downwards.
X
To close the battery compartment:
insert battery compartment cover = start-
ing with retaining lugs ? into the battery
compartment and allow catch tab ; to
engage in place.
On the cordless headphones
The battery compartment cover is located on
the left headphone.
Battery compartment cover
:
The wireless headphones contain 2 type AAA,
1.5 V batteries.
X
To open the battery compartment: flip
battery compartment cover : upwards.
As you do so, hold the left-hand side of the
headphones as shown to prevent the bat-
teries from falling out.
X
Remove the discharged batteries from the
tray.
X
Insert the new batteries. Observe the polar-
ity markings on the batteries and battery
compartment when doing so.
Left-hand battery: The positive pole (+)
must face upwards.
Right-hand battery The positive pole (+)
must face downwards.
X
To close the battery compartment:
press battery compartment cover down-
wards until it engages into place.
If the batteries have been inserted cor-
rectly, the indicator lamp will light up green
when the headphones are switched on.

Basic functions

Operating with headphones
You can use the cordless headphones sup-
plied and/or up to two sets of corded head-
phones connected to the corresponding jack
of the rear-compartment screens
( Y page 35).
The following information can be found in the
"Cordless headphones" section:
switching the wireless headphones on/off
R
( Y page 38).
adjusting the headphone volume
R
( Y page 38).
selecting a screen for the headphones
R
( Y page 38).
Using the main loudspeakers
This function is available in conjunction with
COMAND.
You can use the vehicle loudspeakers to lis-
ten to a disc inserted in the rear-compartment
drive. To do so, at least one of the rear-com-
partment screens must be set to disc mode.
X
Setting using COMAND: press, for exam-
ple, the $ function button to switch on
an audio mode.
X
Audio
Select by sliding ZV the COMAND
controller and press W to confirm.
The Audio menu appears.
X
Rear
Select by turning cVd the COMAND
controller and press W to confirm.
Basic functions
Z
245