Mercedes-Benz COMAND Online Supplement Manual page 63

X
Select the desired destination by turning
cVd the COMAND controller and press
W to confirm.
The address entry menu appears again. The
destination address selected has been
entered.
X
To start route calculation: select
and press W to confirm.
Once the route has been calculated, route
guidance begins ( Y
i Further information on the "Last destina-
tions" memory can be found on
Y
( page 95).
Entering a destination using the map
Calling up the map
X
To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X
Destination
Select
tem menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
X
Using map
Select and press W to confirm.
You see the map with the crosshair.
Current vehicle position
:
Crosshair
;
Details of the crosshair position
=
Map scale selected
?
Start
page 75).
in the navigation sys-
Destination entry
Display = depends on the settings selected
in "Map information in the display"
( Y page 99). The current road name can be
shown, provided the digital map contains the
necessary data, or it may show the geo-coor-
dinate position of the crosshair if the geo-
coordinates display is switched on.
Moving the map and selecting the des-
tination
X
To move the map: slide XVY, ZVÆ or
aVb the COMAND controller.
X
To set the map scale: as soon as you turn
cVd the COMAND controller, the scale bar
appears.
X
Turn cVd until the desired scale is set.
Turning clockwise zooms out from the map;
turning anti-clockwise zooms in.
X
To select a destination: press W the
COMAND controller.
If the crosshair lies outside the digital map,
COMAND uses the nearest digitised road
for route calculation. You will see the
crosshair is off the map
the crosshair is located over a body of
water, you will see the message:
tination is located in a body of
water. Please select another des‐
tination.
X
OK
Select and press W to confirm.
If the destination is within the limits of the
digital map, COMAND attempts to assign
the destination to the map.
If the destination can be assigned, you will
see the address entry menu with the
address of the destination. If not, you will
Destination from map
see the
X
To start route calculation: select
and press W to confirm.
61
The
message. If
The des‐
entry.
Start
Z